International Journal of Computational and Experimental Science and Engineering

2019 Cilt: 5 - Sayı: 3

511 187

İÇİNDEKİLER

Experimental Investigation of Surface Roughness of Cutting Parameters in T6 Aluminum Alloy Milling Process

Neslihan ÖZSOY

51 13

The Effect of Exhaust Temperature on Urea-Water Decomposition in Marine SCR Systems

Kubilay BAYRAMOĞLU, Güner ÖZMEN, A. Güldem CERİT

96 50

Determination of the Radiation Dose Level in Different Slice Computerized Tomography

Osman GÜNAY, Özcan GÜNDOĞDU, Mustafa DEMİR, Mohammad ABUQBEİTAH, Doğan YAŞAR, Serpil AKÖZCAN, Enis KAPDAN, Onur YARAR

50 12

Optimization of Air Distribution in A Non-Ducted Concealed Type Fancoil Unit Heat Exchanger

Murat OZSOY, Canberk YUCEL, Onur VARLICA, Serhan KILIÇ, Kagan KAPLAN

39 17

Research and application of DCA microspheres as deep profile control agent in low permeability reservoir

Xuedong SHİ, Xiang’an YUE, Mingda DONG, Changchun YANG

44 13

Investigation From Different Calculation Solutions In Vertebra Plans And The Reliability Of Different Dose Rate Dose

Yonca Yahşi ÇELEN, Hazım Orhan KIZILKAYA

45 14

Vibration Behavior of Composite Materials Produced by Waste Metal Recycling

Aydın GÜNEŞ, Erdi GÜLBAHÇE, Emin SALUR, Abdullah ASLAN, Ömer Sinan ŞAHİN

48 24

Investigation of The Effect of Intermediate Dose Calculation Module on Dose Dıstrıbutıon in Lung Cancer Radiotherapy Patients

Yonca YAHŞİ ÇELEN, Hazım Orhan KIZILKAYA

49 15

Comparing the Effect of Process Fluid for Wet Ground Heat Exchanger

Ufuk DURMAZ, Orhan YALÇINKAYA

50 18

Recycling and Characterization of Metallic Chips Using Powder Metallurgy

Handan DEMİREL, Aydın GÜNEŞ, Ömer Sinan ŞAHİN

39 11
  • Başlangıç: 2015
  • Yayıncı: Prof.Dr. İskender Akkurt

17.9b 6b

Arşiv

Arşiv